The short version of RP-HPLC fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2026-05-10. Anything still debated is marked as such rather than presented as settled.
Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.
Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and its calculated monoisotopic mass is approximately 390.35 daltons. The compound does not occur naturally as a free peptide; it is produced by solid-phase peptide synthesis. Because it contains two acidic residues and no basic residues, the neutral form carries a net negative charge at physiological pH. This charge profile influences how the peptide behaves in solution and during chromatographic analysis.
Short peptides such as AEDG are normally supplied as a freeze-dried solid and are kept dry, cold, and shielded from light. Holding at minus twenty degrees Celsius is common for the long term, while a refrigerator suffices for brief periods before use. The material takes up moisture to some degree, so containers should stay sealed and be allowed to reach room temperature before opening, which limits condensation on the contents. Repeated warming and cooling of a single container is discouraged because it admits water and can lower the amount of intact peptide.
Dissolution is usually performed in water or a suitable aqueous buffer, and the resulting liquid is divided into single-use portions before freezing. Freeze-thaw cycling is a recognised source of loss for short peptides, since each cycle can encourage aggregation or adsorption onto container walls. Working solutions are generally kept cold and used within a short window, although published stability data specific to epitalon are thin. Containers should be marked with concentration and date, and solutions examined for cloudiness before use.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C14H22N4O9 | Free acid form of the tetrapeptide |
| Molecular mass | About 390.35 Da | Calculated monoisotopic value |
| Appearance | White to off-white powder | Typical lyophilized presentation |
| Solubility | Soluble in water | Also dissolves in buffered saline |
| Storage temperature | Minus 20 degrees Celsius | Dry, dark conditions; avoid repeated thawing |
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, commonly abbreviated AEDG. It was designed at the St. Petersburg Institute of Bioregulation and Gerontology as a short, chemically defined analogue of epithalamin, a fraction obtained from bovine pineal tissue. Small peptide bioregulators of this type formed a long-running line of work there from the 1980s onward. Because the molecule is produced by solid-phase synthesis rather than extraction, its composition is exact and its purity can be measured directly.
The most frequently cited proposed action is induction of telomerase, the enzyme that adds repeat sequences to chromosome ends. Cell-culture work from the originating group reported higher telomerase reverse transcriptase expression and measurable telomere elongation in human somatic cells after exposure. How a four-residue peptide would reach nuclear gene regulation is not established, and no cell-surface receptor or uptake route has been identified. Additional reports describe changes in melatonin secretion, antioxidant enzyme activity and lipid peroxidation in aged animals, but these findings remain mechanistically unconnected to the telomerase observation.
Published evidence comes mainly from Russian-language journals and from a single research group, with small sample sizes and limited independent replication. A few laboratories outside that group have examined related peptides and reported weaker or absent telomerase effects, so the central claim is best described as contested rather than settled. Rodent studies report modest changes in some ageing markers and in survival, but designs vary and control conditions are often sparse. No large randomised trial in humans has been published, and long-term safety data in healthy populations are correspondingly thin.
Solubility is high in water, phosphate-buffered saline and normal saline, a pattern that follows from the two acidic residues in the chain. The peptide dissolves poorly in non-polar solvents such as hexane or chloroform. Stock solutions are often prepared in water first and then diluted into the buffer of interest. Because the molecule is small and hydrophilic, filtration through a low-protein-binding membrane is usually straightforward, and visible particulates are uncommon in freshly made solutions.
Identity and purity are established with reversed-phase high-performance liquid chromatography and mass spectrometry. The chromatogram shows the main peak and any truncated or oxidised by-products, while the mass spectrum confirms the expected 390 dalton mass. Amino acid analysis can corroborate composition when a sample's origin is uncertain. Counterion content, particularly residual trifluoroacetate from purification, is frequently reported alongside purity because it shifts the net mass of the solid.
Material supplied for laboratory use is normally a lyophilised white to off-white powder that dissolves readily in water and in isotonic saline. Lyophilised cakes are hygroscopic and should be equilibrated to room temperature before opening to limit condensation on the solid. Solutions are typically prepared at milligram-per-millilitre concentrations and divided into single-use aliquots, because repeated freeze–thaw cycles degrade short peptides. Aqueous solutions are far less stable than the dry powder, and identity is usually verified by mass spectrometry alongside purity estimation from reversed-phase high-performance liquid chromatography.
Epitalon is a synthetic linear tetrapeptide with the sequence alanine–glutamate–aspartate–glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and the calculated mass is approximately 390.35 g/mol. The compound is made by solid-phase peptide synthesis rather than extracted from tissue, although early work described it as a short fragment of a peptide fraction obtained from bovine pineal extract. In the research literature the spelling epitalon and the variant epithalone both appear, while AEDG is the standard code used in peptide nomenclature.
Several names circulate for the same molecule, including epitalon, epithalone, epithalamin tetrapeptide, and the sequence code AEDG. A CAS registry number, 307297-39-8, is commonly cited for it, though catalogue entries should be checked against supplier documentation because mislabelled records occur. In its usual form the peptide carries free amino and carboxyl termini and is neither glycosylated nor lipidated. Researchers distinguish the defined tetrapeptide from epithalamin itself, a crude pineal preparation containing many peptides that is not chemically characterised.
Material sold for research use varies widely in documented quality. A useful verification package includes a certificate of analysis that states peptide content rather than only net weight, the chromatographic method and column used, and a mass spectrum consistent with the expected mass. Independent testing by a third-party laboratory is occasionally reported. Statements of identity resting only on a supplier label provide little assurance, and the gap between nominal mass and actual peptide content can be substantial once counterions and residual water are counted.
Peptides of this size are generally stable as dry solids but degrade in solution over time. The principal routes are hydrolysis of the peptide backbone and oxidation, with hydrolysis favoured by elevated temperature and extreme pH. Aqueous solutions held at room temperature can show measurable loss of purity within days, while frozen aliquots are considerably more durable. Because the sequence contains neither cysteine nor methionine, oxidation is less of a concern than for many other peptides, but pH control during handling still matters.
=== Terms used for classifying protein structures and sequences === The more commonly used terms for evolutionary and structural relationships among proteins are listed below. Many additional terms are used for various kinds of structural features found in proteins. Descriptions of such terms may be found at the CATH Web site, the Structural Classification of Proteins (SCOP) Web site, and a Glaxo Wellcome tutorial on the Swiss bioinformatics Expasy Web site.
== Introduction == Although the term fluid generally includes both the liquid and gas phases, its definition varies among branches of science. Definitions of solid vary as well, and depending on field, some substances can have both fluid and solid properties. Non-Newtonian fluids like Silly Putty appear to behave similar to a solid when a sudden force is applied. Substances with a very high viscosity such as pitch appear to behave like a solid (see pitch drop experiment) as well. In particle physics, the concept is extended to include fluidic matters other than liquids or gases. A fluid in medicine or biology refers to any liquid constituent of the body (body fluid), whereas "liquid" is not used in this sense. Sometimes liquids given for fluid replacement, either by drinking or by injection, are also called fluids (e.g. "drink plenty of fluids"). In hydraulics, fluid is a term which refers to liquids with certain properties, and is broader than (hydraulic) oils.
Gibson described the script as having "a real innocence and charm" and had praised Abrams' previous script, which was made into the film Regarding Henry. Gibson originally wanted the lead role, which eventually went to Harrison Ford, and insisted on seeing Abrams' next film script.
Sources: en.wikipedia.org
== General and cited references == Sherman, Philip (1963). Rheology of Emulsions: Proceedings of a symposium held by the British Society of Rheology ... Harrogate, October 1962. British Society of Rheology / Macmillan. ISBN 9780080102900. Nalwa, H. S., ed. (2000). Handbook of Nanostructured Materials and Nanotechnology. Vol. 5. New York: Academic Press. pp. 501–575.
One application of thermal ionization is thermal ionization mass spectrometry (TIMS). In thermal ionization mass spectrometry, a chemically purified material is placed onto a filament which is then heated to high temperatures to cause some of the material to be ionized as it is thermally desorbed (boiled off) the hot filament. Filaments are generally flat pieces of metal around 1–2 mm (0.039–0.079 in) wide, 0.1 mm (0.0039 in) thick, bent into an upside-down U shape and attached to two contacts that supply a current. This method is widely used in radiometric dating, where the sample is ionized under vacuum. The ions being produced at the filament are focused into an ion beam and then passed through a magnetic field to separate them by mass. The relative abundances of different isotopes can then be measured, yielding isotope ratios. When these isotope ratios are measured by TIMS, mass-dependent fractionation occurs as species are emitted by the hot filament. Fractionation occurs due to the excitation of the sample and therefore must be corrected for accurate measurement of the isotope ratio. There are several advantages of the TIMS method. It has a simple design, is less expensive than other mass spectrometers, and produces stable ion emissions. It requires a stable power supply, and is suitable for species with a low ionization energy, such as strontium and lead. The disadvantages of this method stem from the maximum temperature achieved in thermal ionization.
According to Christian Science Monitor in 1980, "although his business dealings with the Soviet Union were cut short when Stalin came to power, he had more or less single-handedly laid the groundwork for the [1980] state of Western trade with the Soviet Union." Kissinger and Nixon were "realists" who deemphasized idealistic goals like anti-communism or promotion of democracy worldwide because those goals were too expensive in terms of America's economic capabilities. They rejected "idealism" as impractical and too expensive, and neither man showed much sensitivity to the plight of people living under communism. Kissinger's realism fell out of fashion as idealism returned to American foreign policy with Carter's moralism emphasizing human rights, and Reagan's rollback strategy aimed at destroying communism.
Sources: en.wikipedia.org
Epitalon is a synthetic tetrapeptide built from four amino acids: alanine, glutamate, aspartate, and glycine. It is not extracted from a natural source but made in the laboratory by chemical synthesis. Its short length makes it relatively straightforward to produce at high purity.
No naturally occurring free form of the peptide has been described. The four-amino-acid sequence can appear as a fragment within larger proteins, but that is not the same as the intact compound being present as a circulating molecule. Materials used in research are synthetic.
Purity is usually checked by reverse-phase high-performance liquid chromatography, which separates the target peptide from related impurities. Mass spectrometry is commonly used alongside it to confirm molecular mass. Some suppliers also provide amino acid analysis for additional sequence confirmation.
Reversed-phase high-performance liquid chromatography is run alongside mass spectrometry. The chromatogram separates components and gives a purity figure, while the mass spectrum confirms that the measured molecular mass matches the expected sequence. Neither measurement on its own is treated as sufficient.