reversed-phase HPLC comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Last reviewed on 2026-01-28. Where a claim depends on a specific study, the study is described rather than over-claimed.
Reference material is normally supplied as a lyophilised powder in a sealed vial. Product literature typically recommends storage at minus twenty degrees Celsius or colder, protected from light and moisture. Freeze-thaw cycling is usually avoided because repeated condensation can introduce water into the vial. Working solutions are commonly prepared fresh, aliquoted, and kept cold for short periods rather than stored at ambient temperature. Labelling the date of opening helps track how long a vial has been in use.
Solubility is high in water, phosphate-buffered saline and normal saline, a pattern that follows from the two acidic residues in the chain. The peptide dissolves poorly in non-polar solvents such as hexane or chloroform. Stock solutions are often prepared in water first and then diluted into the buffer of interest. Because the molecule is small and hydrophilic, filtration through a low-protein-binding membrane is usually straightforward, and visible particulates are uncommon in freshly made solutions.
Identity and purity are established with reversed-phase high-performance liquid chromatography and mass spectrometry. The chromatogram shows the main peak and any truncated or oxidised by-products, while the mass spectrum confirms the expected 390 dalton mass. Amino acid analysis can corroborate composition when a sample's origin is uncertain. Counterion content, particularly residual trifluoroacetate from purification, is frequently reported alongside purity because it shifts the net mass of the solid.
Epitalon is a synthetic linear tetrapeptide with the sequence alanine–glutamate–aspartate–glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and the calculated mass is approximately 390.35 g/mol. The compound is made by solid-phase peptide synthesis rather than extracted from tissue, although early work described it as a short fragment of a peptide fraction obtained from bovine pineal extract. In the research literature the spelling epitalon and the variant epithalone both appear, while AEDG is the standard code used in peptide nomenclature.
Several names circulate for the same molecule, including epitalon, epithalone, epithalamin tetrapeptide, and the sequence code AEDG. A CAS registry number, 307297-39-8, is commonly cited for it, though catalogue entries should be checked against supplier documentation because mislabelled records occur. In its usual form the peptide carries free amino and carboxyl termini and is neither glycosylated nor lipidated. Researchers distinguish the defined tetrapeptide from epithalamin itself, a crude pineal preparation containing many peptides that is not chemically characterised.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilised and often hygroscopic |
| Solubility class | Freely soluble in water | Poor solubility in non-polar solvents |
| Typical storage temperature | -20 degrees Celsius or colder | Sealed, desiccated, protected from light |
| Typical analytical method | Reversed-phase HPLC with mass spectrometry | Establishes purity and confirms mass |
| Common salt form | Trifluoroacetate or acetate | Counterion reported alongside purity values |
Typical storage for the lyophilized powder is −20 °C or lower, in a sealed container protected from light and moisture. Hygroscopic material should be allowed to equilibrate to room temperature before the vial is opened, which limits condensation on the contents. Working solutions are commonly divided into single-use aliquots and frozen to avoid repeated freeze-thaw cycles. Dilute solutions are more prone to adsorption onto plastic surfaces and to loss during filtration, so procedures that minimize transfers and use low-binding labware are preferable.
Reversed-phase high-performance liquid chromatography is the standard approach for assessing purity, usually with ultraviolet detection near 214 nm, where the peptide bond absorbs. Mass spectrometry, most often with electrospray ionization, confirms the molecular mass and helps reveal truncation or deletion byproducts. Amino acid analysis can verify composition, and counterion content is sometimes measured because peptides purified with trifluoroacetic acid retain variable amounts of that salt. Purity figures reported without a stated method and detection wavelength are difficult to interpret.
Epitalon is a synthetic tetrapeptide with the amino acid sequence alanine-glutamate-aspartate-glycine, abbreviated Ala-Glu-Asp-Gly or AEDG. It was developed by the Russian researcher Vladimir Khavinson and colleagues during work on peptide bioregulators derived from the pineal gland. The compound is short enough to be produced by standard solid-phase peptide synthesis and is typically handled as a lyophilized white powder. Its small size distinguishes it from larger pineal peptides such as epithalamin, a complex extract from which the tetrapeptide was conceptually derived.
The four residues give epitalon a molecular formula of C14H22N4O9 and a molecular weight near 390.35 daltons. The presence of two acidic residues, glutamate and aspartate, makes the free peptide strongly acidic, while the alanine and glycine ends provide neutral, nonpolar character. This combination produces a molecule with substantial water solubility. Because there are no cysteine, methionine, or tryptophan residues, the peptide lacks the most common oxidation-sensitive side chains, which simplifies handling compared with many longer peptides.
The proposed relationship between epitalon and pineal function is a central part of its background. Khavinson's group reported that short peptides corresponding to regions of larger pineal proteins could influence gene expression in cells. Epitalon was framed as a synthetic analogue of an active fragment rather than a direct isolation product. Whether the tetrapeptide reproduces the effects of the parent extract is an open question, because comparative studies are limited and the parent extract itself is not a single defined substance.
Storage practice centres on limiting moisture, oxygen, and repeated temperature cycling. Freeze-dried powder is generally held desiccated at minus twenty degrees Celsius or colder and protected from light. Reconstituted solutions are markedly less stable, and the aspartate-glycine junction is prone to succinimide formation at neutral to mildly alkaline pH. Portioning material into single-use aliquots reduces degradation compared with repeated freeze-thaw cycles. Stability data specific to this tetrapeptide remain scarce, so most handling guidance is extrapolated from general peptide chemistry rather than measured directly.
Documentation accompanying research peptides usually includes a certificate of analysis listing the batch number, purity figure, and test methods applied. Buyers comparing suppliers should check whether the reported purity refers to chromatographic area or to a mass-balance calculation, because the two are not equivalent. Counter-ion content, residual solvents, and water content are sometimes omitted from such certificates even though they affect the actual peptide mass present. Independent verification through a second laboratory is the most direct way to confirm that a supplied material matches its label.
Purity assessment of peptide reagents normally relies on reversed-phase high-performance liquid chromatography. A gradient of acetonitrile in water with trifluoroacetic acid, paired with a C18 stationary phase, separates the target tetrapeptide from truncated sequences and deletion analogues. Detection at 214 nanometres exploits absorbance of the peptide backbone, since the molecule contains no aromatic residue. Results are expressed as a percentage of total peak area. Values above ninety-five percent are typical for research-grade material, although reporting conventions vary between suppliers.
== Use in protein biochemistry == In biochemical analyses of membrane proteins, such as BN-PAGE, ε-aminocaproic acid is used to enhance membrane protein solubility while avoiding the addition of sodium chloride.
While P-51s used 110-US-gallon (420 L) drop tanks over Europe, for Japan they frequently used 165-US-gallon (620 L) drop tanks which allowed more loitering time over Japan. While USAAF B-17 and B-24 bombers in Europe were arranged in combat box formations, over Japan the B-29s formed a stream that could stretch up to 200 miles. The escorting P-51s formed three Tar-Cap (Target Combat Air Patrol) squadrons, two squadrons flying on one side of the B-29 stream and the third on the other side, each squadron being 2,000 feet above and 4,000 to 5,000 feet laterally from the bomber stream. Compared to its Japanese adversaries, the P-51 largely outclassed the Imperial Japanese Army Air Service's aging A6M Zero (the most numerous Japanese fighter available), as the A6M's poor high-altitude performance put it at a disadvantage in the P-51's favorable performance envelope. When the P-51 was used for interdiction or strike missions, the A6M was slower but could still out-turn or out climb the P-51 at low to medium altitude. Newer Japanese designs were potent but too few in number. The Kawanishi N1K-J Shiden was fast and agile, but not effective as an interceptor due to a poor rate of climb and reduced engine performance at high altitude. The Imperial Japanese Army Air Service's Nakajima Ki-84 Hayate had performance and an operation ceiling that could match the P-51, however the Ki-84 suffered from manufacturing defects, and its high-maintenance Nakajima Homare engine could not reach its full potential due to lack of ample high-octane fuel.
==== MeSH D12.125.067 – amino acids, acidic ==== MeSH D12.125.067.500 – aspartic acid MeSH D12.125.067.500.150 – d-aspartic acid MeSH D12.125.067.500.275 – isoaspartic acid MeSH D12.125.067.500.400 – n-methylaspartate MeSH D12.125.067.500.700 – potassium magnesium aspartate MeSH D12.125.067.750 – glutamic acid MeSH D12.125.067.750.150 – 1-carboxyglutamic acid MeSH D12.125.067.750.400 – glutamates MeSH D12.125.067.750.400.700 – polyglutamic acid MeSH D12.125.067.750.400.800 – sodium glutamate MeSH D12.125.067.750.700 – pyrrolidonecarboxylic acid
Sources: en.wikipedia.org
Like all governing institutions in mainland China, Ningxia has a parallel party-government system, in which the CCP Ningxia Regional Committee secretary outranks the government chairman. The CCP Ningxia Regional Committee acts as the top policy-formulation body, and has control over the Ningxia Hui Autonomous Region People's Government.
=== Cysteine and cystine === As the functional group of the proteinogenic amino acid cysteine, the thiol group plays a very important role in biology. When the thiol groups of two cysteine residues (as in monomers or constituent units) are brought near each other in the course of protein folding, an oxidation reaction can generate a cystine unit with a disulfide bond (−S−S−). Disulfide bonds can contribute to a protein's tertiary structure if the cysteines are part of the same peptide chain, or contribute to the quaternary structure of multi-unit proteins by forming fairly strong covalent bonds between different peptide chains. A physical manifestation of cysteine-cystine equilibrium is provided by hair straightening technologies. Sulfhydryl groups in the active site of an enzyme can form noncovalent bonds with the enzyme's substrate as well, contributing to covalent catalytic activity in catalytic triads. Active site cysteine residues are the functional unit in cysteine protease catalytic triads. Cysteine residues may also react with heavy metal ions (Zn2+, Cd2+, Pb2+, Hg2+, Ag+) because of the high affinity between the soft sulfide and the soft metal (see hard and soft acids and bases). This can deform and inactivate the protein, and is one mechanism of heavy metal poisoning.
As of December 2019, there is no effective pharmacotherapy for amphetamine addiction. Reviews from 2015 and 2016 indicated that TAAR1-selective agonists have significant therapeutic potential as a treatment for psychostimulant addictions; however, as of February 2016, the only compounds which are known to function as TAAR1-selective agonists are experimental drugs. Amphetamine addiction is largely mediated through increased activation of dopamine receptors and co-localized NMDA receptors in the nucleus accumbens; magnesium ions inhibit NMDA receptors by blocking the receptor calcium channel. One review suggested that, based upon animal testing, pathological (addiction-inducing) psychostimulant use significantly reduces the level of intracellular magnesium throughout the brain. Supplemental magnesium treatment has been shown to reduce amphetamine self-administration (i.e., doses given to oneself) in humans, but it is not an effective monotherapy for amphetamine addiction. A systematic review and meta-analysis from 2019 assessed the efficacy of 17 different pharmacotherapies used in randomized controlled trials (RCTs) for amphetamine and methamphetamine addiction; it found only low-strength evidence that methylphenidate might reduce amphetamine or methamphetamine self-administration.
Atomic nuclei consist of protons and neutrons bound together by the residual strong force. Because protons are positively charged, they repel each other. Neutrons, which are electrically neutral, stabilize the nucleus in two ways. Their copresence pushes protons slightly apart, reducing the electrostatic repulsion between the protons, and they exert an attractive nuclear force on each other and on protons. For this reason, one or more neutrons are necessary for two or more protons to bind into a nucleus. As the number of protons increases, so does the ratio of neutrons to protons necessary to ensure a stable nucleus (see graph at right). For example, although the neutron:proton ratio of 32He is 1:2, the neutron:proton ratio of 23892U is greater than 3:2. A number of lighter elements have stable nuclides with the ratio 1:1 (Z = N). The nuclide 4020Ca (calcium-40) is observationally the heaviest stable nuclide with the same number of neutrons and protons. All stable nuclides heavier than calcium-40 contain more neutrons than protons.
Sources: en.wikipedia.org
Sealed lyophilised powder is normally kept at minus twenty degrees Celsius or below, away from light and moisture. Vials are allowed to reach room temperature before opening to limit condensation. Repeated warming and cooling of the same vial is discouraged.
Reversed-phase HPLC establishes purity and separation from related peptides, and mass spectrometry confirms the molecular mass. Amino acid analysis can verify residue composition. No single method proves identity on its own, so the results are read together.
Yes. Residual trifluoroacetate or acetate from purification adds mass and can shift the value obtained by certain assays. Purity figures are therefore meaningful only when the counterion form is stated. Reporting both peptide content and salt form gives a clearer picture.
It is a synthetic tetrapeptide. Its sequence was derived from research on peptide fractions of bovine pineal extract, and the intact AEDG sequence has not been demonstrated as an abundant free peptide in human tissue.